The power distribution room, Power Generation Room, Switchgear, and Substations are places where easy to catch fire, because a lot of electrical cabinets and control panels are over there, it is necessary to have an aerosol extinguishing system installed in these fire-prone areas.
Du kan lita fullständigt på vårt brandskyddssystem för miniaerosol eftersom det använder innovativ nanodämpningsteknik och har nu använts flitigt i många industrier, som transportbranschen, marin industri, olje- och gasindustrin, gruvindustri, tillverkningsindustrin, flygindustrin, ny energiindustri, etc.
We have many international cases of its application inpower distribution roomsand corresponding electrical cabinets.
Here we recommend a 750 grams electrically activated aerosol fire protection system, its basic technical data are as follows:
Modell: 750E (AW-QH-750E)
Product Measurement: 167 mm in diameter, och 204 mm in height.
Släckningsvolym: 7.5 kubikmeter.
Brandsläckningstid: 14 till 15 sekunder.
Weight of Aerosol Fire Extinguishing Agent: 750 gram.
Starting Method: Elektrisk aktivering, electronics, electric power supply, DC 3-24 volt, and AC 3-220 volt.
The Aerosol Agent Color is brown.
Cylinder Color and Material: 304 rostfritt stål med silvervit färg.
Weight of the Fire Extinguishing Generator: 5400 gram.
Produktens livslängd: 10 till 15 år.
Fire Extinguishing Ability Class: Class A, Klass B, Klass C, Class E and Class F.
When installing this product in a power distribution room, please have the installer wear anti-static clothing to avoid the product being activated by static electricity.
dessutom, be sure to install the product without power on!
Please use the correct wiring method. För mer detaljer, se vår installation guide.
Because all distribution rooms have electrical cabinets or control cabinets, we recommend installing an aerosol fire protection system on these electrical cabinets. The suitable model is a150-gram thermally activated aerosol extinguisher.
This product has many special features:
The power distribution room normally is not able to install abig fire suppression system, like an FM200 system, Novec1230 system, or foam system, while a mini aerosol system is an alternative.
There are many electrical cabinets or control panels in a power distribution room, so aerosol cannot only be installed inside the room but also can be installed in the cabinet.
Aerosol is a clean agent, after release, it leaves little residue and is very easy to sweep up.
It is non-conductive and very friendly to power distribution equipment.
DIY to install, just only need a small bracket and several small screws to install, or just use several small magnets together with a 3M brand of glue to install it.
Miljövänlig, won't damage the ecosystem.
Instantaneous fire extinguishing takes only a few seconds to extinguish the fire.